Hengshui Qianjin Engineering Rubber and Plastic Co., Ltd.

3. The first picture of sales channels
Back-attached rubber waterstop, middle-buried rubber waterstop, the price goes up, direct purchasing goes forward, back-attached rubber waterstop, middle-buried rubber waterstop, price goes forward, direct purchasing goes forward. Priority, back-attached rubber waterstop, middle buried rubber waterstop, price advance, direct procurement, advance priority, back-attached rubber waterstop, middle buried rubber waterstop, price advance, direct procurement, advance priority, back-attached rubber waterstop, middle Buried rubber waterstop price advance, direct procurement priority
Where to choose rubber waterstop, Hengshui Qianjin Rubber and Plastic (middle buried type) external rubber waterstop. Precautions for construction of rubber waterstop in construction During the process, since there are many sharp stones and sharp steel bars in the concrete, when pouring and positioning the waterstop, attention should be paid to the impact of the pouring to avoid puncturing the rubber waterstop due to excessive force. If cracks are found, they should be repaired in time, otherwise the ability of the rubber waterstop to resist external forces will be greatly reduced when the joints are deformed and subjected to water pressure. When fixing the waterstop, you can only make holes in the permitted parts of the waterstop and do not damage any parts of the waterstop. When positioning the rubber waterstop, be sure to keep it flat at the interface, and do not allow the waterstop to roll or kink. If any kinks are found, they should be adjusted in time. When pouring and fixing the waterstop, prevent the waterstop from rolling or kinking. The water belt should be offset to avoid shortening on one side and affecting the water stop effect. When pouring concrete, it must be fully vibrated to prevent the water stop from being poorly combined with the concrete and affecting the water stop effect. The waterstop joints must be well bonded. If the construction site conditions are suitable, the hot vulcanization method can be used. The so-called overlapping without any treatment is absolutely not allowed.
The correctness of the construction and installation methods of rubber waterstops is the key to using rubber waterstops. We know that rubber waterstops are partially or fully buried in the concrete during the concrete pouring process. Since there are many sharp stones and sharp steel bars in the concrete, during the positioning of the waterstop and the pouring of concrete, attention should be paid to the installation positioning method and pouring pressure to prevent the waterstop from being punctured. Since the tear strength of plastic and rubber is 3 times lower than the tensile strength, if the product is punctured, it will greatly reduce the product's ability to resist external forces, so special attention must be paid during construction.
3 middle buried rubber waterstops